The 3 Best Stands and Mounts for Electronic Drum Sample Pads (2026)

A sample pad is easier to play when it’s within reach and stays steady under a hard stroke. A separate stand gives it its own base, while a clamp frees up space around your feet.
My top pick is the Roland PDS-20 for a Roland SPD or HandSonic. It includes the Roland mounting plate and gives you room to adjust the pad’s height and angle.
My second pick is the Gibraltar 6713E. It gives a pad with a compatible post and plate its own stand at seated playing height.
Contents
The Best Stands and Mounts for Electronic Drum Sample Pads (2026)
1. Roland PDS-20
Pros
- Includes the Roland mounting plate
- Double-braced stand with a geared tilt adjustment
Cons
- Needs its own floor space
The PDS-20 includes the plate that bolts to supported Roland SPD and HPD instruments. The tripod adjusts from 650 to 1,050 mm and the geared tilt lets you set the playing angle independently of the stand height.
With the stand’s own base under the pad, you can change the angle without moving a cymbal stand or shifting anything on the rack. That’s especially useful if the same pad doubles as a standing percussion setup.
2. Gibraltar 6713E
Pros
- Separate double-braced base
- Works with a compatible post-style electronic mount
Cons
- Requires a compatible instrument plate
Gibraltar’s 6713E adjusts from 26.5 to 37 inches. It puts a seated pad near the surrounding drums, but tops out about four inches below the PDS-20.
The 6713E makes the most sense when you already have the plate. Starting without one means buying the hardware separately, whereas the PDS-20 comes with the Roland plate.
3. Gibraltar SC-EMBA
Pros
- Reaches into a crowded setup without another tripod
- Tilt can be adjusted independently of the host stand
Cons
- Requires a stable host stand and matching mounting hardware
The SC-EMBA is the space-saving choice if the floor is already full. Its 16-inch knurled boom has a 12.7 mm diameter and a rotating grabber clamp. Confirm that the accessory holder on your rack or stand takes that boom and that the pad has the correct mounting post.
The boom puts the pad where a tripod might get in the way. A large pad adds leverage when it sits well out from the clamp, so the SC-EMBA is best when the playing surface can stay close to the support.
Will any sample pad fit any stand?
Check the attachment under the instrument before ordering. A threaded socket, a four-screw plate and a snare-style basket are different systems. A stand can accept the mounting post while the plate itself still fails to match the hole pattern on the pad.
If you share a rack with other hardware, check the clamp’s fit around the rack tube too. The mounting hardware has to match at both ends.
Where should you mount a sample pad?
Set the centre of the pad near an easy playing height and angle before you worry about the last inch of reach. Try a stroke on every corner with the adjacent cymbal or hi-hat in its normal position. If the pad triggers backing tracks, make sure the controls and cables remain easy to reach once you are sitting behind the kit.
Verdict
I’d start with the PDS-20 for a supported Roland pad, or the 6713E if the pad already has a compatible mounting post. The SC-EMBA is the better use of space when the rack or a sturdy stand can take the extra load.
See our electronic drum pad guide for more.






